Same Great Benefits as RPM’s Original Formula Plus higher alkalinity for increased SPS growth in higher nutrient aquariums!
Fritz Reef Pro Mix (RPM) HIGH ALK Formula is manufactured using only the highest quality raw materials. RPM HIGH ALK Formula contains all of the necessary major and minor elements of natural sea water that are utilized by living marine and reef animals along with enhanced alkalinity. Increased alkalinity has been shown to increase the growth of SPS. Fritz Reef Pro Mix HIGH ALK Formula Salt is manufactured in our own facility in small batches to ensure complete quality control, rather than outsourced to generic chemical blender with uncertain quality standards. Our salt blending equipment id devoted solely to the production of marine salt blends, preventing contamination issues. Fritz’s unique production process salts. Each batch is assigned a lot number and tested by in-house quality control to ensure its chemical quality, purity and consistency before it is shipped. RPM is used by public aquariums, zoos, research institution, destination retail locations and hobbyists worldwide
CALCIUM 400-450 ppm
MAGNESIUM 1300-1400 ppm
ALKALINITY 10 - 11.5dkh
STRONTIUM 9 ppm
POTASSIUM 400 ppm
*Parameters reflect Fritz Aquatics’ QC pass ranger, the median is targeted. Be aware source water can greatly affect parameters, especially alkalinity. QC is conducted using RO/DI at a neutral pH and a TDS of 0.
Directions & Dosage
For best results, it is important to follow proper mixing instructions when using salt with elevated parameters like Fritz Aquatics Reef Pro Mix. See below for best practices when using RPM.
When mixing Fritz Reef Pro Mix, it is best to use RO/DI water quality checked by a TDS meter (TDS should be less than 10 ppm, 0 is preferred). Fill a clean mixing container (dedicated to saltwater mixing only) with desired amount of water to be prepared. For best results, use water between 70°-75°F (21°-24°C) when mixing RPM. Slowly add desired amount of RPM to the water to avoid an increase in temperature and precipitation. This helps to prevent precipitation of calcium, alkalinity and other elements. It is recommended to use a mixing pump and an airstone when mixing RPM. This will also help to avoid concentrated areas of material and precipitation. Using a properly calibrated refractometer, bring the water to the desired salinity. Once mixed to a clear solution, add a heater to the water to bring to the current temperature of your aquarium. It is recommended to allow two hours before performing a water change. If water does not mix clear, please contact us for further mixing tips before performing a water change.
DO NOT MIX DRY SALT DIRECTLY INTO SYSTEMS WITH LIVESTOCK PRESENT!
CAUTION: Keep out of reach of children. Not for human consumption. Generates slight heat when added to water; avoid handling with wet hands. Contact with dry powder may cause skin and/or eye irritation. In case of contact, flush eyes with cool water and seek immediate medical attention.
Storage: Store in a cool, dry place. Keep product tightly sealed.